O2 voltage conversion
#1
Senior Member
Thread Starter
Join Date: Feb 2001
Location: GA
Posts: 652
Likes: 0
Received 0 Likes
on
0 Posts
O2 voltage conversion
Does anyone have or know where I can find an equation or chart of some sort that converts readings from a standard 0-1 Volt O2 sensor to air fuel or lamda values? I have been looking all over the place and every chart I run across is so vague it's useless.
#2
This page (http://www.techedge.com.au/vehicle/wbo2/wbntk.htm) has a general graph, and I think there are others on this site. The stock-style narrow band sensors are worthless for tuning. A minor ground issue is enough to make the reading totally meaningless.
-Max
-Max
#3
Full Member
Join Date: May 2001
Location: Indian Springs, OH USA
Posts: 160
Likes: 0
Received 0 Likes
on
0 Posts
I would also suggest you check:
http://Rx7turbo.com/afhighlight.htm
It shows voltage readouts that work with the 0 to 1 volt air/fuel meter.
Good luck
db
http://Rx7turbo.com/afhighlight.htm
It shows voltage readouts that work with the 0 to 1 volt air/fuel meter.
Good luck
db
Thread
Thread Starter
Forum
Replies
Last Post