Rotary Car Performance General Rotary Car and Engine modification discussions.

is my bridge to thin?

Reply Subscribe

Search this Thread

Old

Feb 26, 2006 | 12:59 PM

#1

Bluem

Thread Starter

Concept Motorsports

Joined: Jun 2002

Posts: 686

Likes: 1

From: San Juan, Puerto Rico

is my bridge to thin?

the bridge on my BP are about half the width of the corner seal, is this bad can it fall out? is this is bad? can i fix it with some welds and resurface the side hosings?

Reply

Old

Feb 26, 2006 | 01:54 PM

#2

GUITARJUNKIE28

multipersonality disorder

Joined: Feb 2002

Posts: 5,656

Likes: 0

From: so. cal

pics?

Reply

Old

Feb 26, 2006 | 07:25 PM

#3

Bluem

Thread Starter

Concept Motorsports

Joined: Jun 2002

Posts: 686

Likes: 1

From: San Juan, Puerto Rico

i dont have any but what i wanna know is if i can weld the hosing to pix it ,and then resurface it

Reply

Old

Feb 27, 2006 | 09:44 PM

#4

wpgrexx

Rotary Enthusiast

Joined: Dec 2001

Posts: 1,350

Likes: 0

From: not in winterpeg anymore

it would be easier and probably cheaper to just report different plates

Reply

Old

Feb 27, 2006 | 09:54 PM

#5

BDC

BDC Motorsports

Joined: Jun 2002

Posts: 3,667

Likes: 6

From: Grand Prairie, TX

half the width of a corner seal? Nah you're fine.

B

Reply

Old

Feb 28, 2006 | 03:18 AM

#6

GUITARJUNKIE28

multipersonality disorder

Joined: Feb 2002

Posts: 5,656

Likes: 0

From: so. cal

but where is it placed?

Reply

Reply Subscribe

Related Topics

Thread

Thread Starter

Forum

Replies

Last Post

hogged out vs boost prepped (Nikki)

Jeff20B

1st Generation Specific (1979-1985)

73

Sep 16, 2018 07:16 PM

FB Engine Bay Wiring Harness Routing Question

scissorhands

New Member RX-7 Technical

0

Sep 16, 2015 01:25 PM

Reply Share

First
Prev
1 / 1
Next
Last

All times are GMT -5. The time now is 03:33 AM.