Help I need info on what my oil pressure guage should read at idle
#1
Full Member
Thread Starter
Join Date: Oct 2001
Location: New York
Posts: 217
Likes: 0
Received 0 Likes
on
0 Posts
Help I need info on what my oil pressure guage should read at idle
I need to know if my autometer guge is reading correctly at idle. At 940-1000 rpm it reads 10psi. Is this ok??? If I lower the RPM to 880 it reads about 5psi-opsi.
I need to know if I'm damaging the engine.
Also what should it be reading on acceleration and on boost??
Any help would be greatly appriciated. Thanks Diego
I need to know if I'm damaging the engine.
Also what should it be reading on acceleration and on boost??
Any help would be greatly appriciated. Thanks Diego
#2
Rotary Enthusiast
10psi is a fraction low, my engine reads about 30psi at idle, up in the rev range it reads up to around 80psi,
my old motor had the same problem a o ring was going in the oil pump and leaking out pressure.
Dale
my old motor had the same problem a o ring was going in the oil pump and leaking out pressure.
Dale
Thread
Thread Starter
Forum
Replies
Last Post
stickmantijuana
20B Forum
8
08-18-15 02:46 PM