Greddy Elbow
Thread Starter
Full Member
Joined: Jan 2007
Posts: 52
Likes: 0
From: UK
Greddy Elbow
I just bought this http://cgi.ebay.co.uk/ws/eBayISAPI.d...MEWA:IT&ih=008
As you can tell it has BOV flange on the side, would it make a difference at all leaving the BOV flange there or re-locating further down away from the elbow? Reason I'm asking is that I wanted to fit the BOV in the pipe extended between the elbow and the intercooler. Also not sure if it will cause issues been a RHD all the fuel lines and other parts are on the left side of the engine bay next to the manifold !!!!
As you can tell it has BOV flange on the side, would it make a difference at all leaving the BOV flange there or re-locating further down away from the elbow? Reason I'm asking is that I wanted to fit the BOV in the pipe extended between the elbow and the intercooler. Also not sure if it will cause issues been a RHD all the fuel lines and other parts are on the left side of the engine bay next to the manifold !!!!
Thread
Thread Starter
Forum
Replies
Last Post
Turblown
Vendor Classifieds
12
Oct 17, 2020 03:25 PM
eplusz
General Rotary Tech Support
15
Oct 7, 2015 04:04 PM