Decided to go 20B NA for my Rx3
#30
Thank you guys I really appreciate all info on my engine built . I値l be posting all my updates on my original post of my Rx3 if you guys want to subscribe and hopefully help me out with future questions .
thanks
https://www.rx7club.com/old-school-o...-733317/page8/
My little work area 20B parts are adding slowly but moving along
How my car used to look before I took it apart because of rust . My buddy had it before me this was his picture he gave me
thanks
https://www.rx7club.com/old-school-o...-733317/page8/
My little work area 20B parts are adding slowly but moving along
How my car used to look before I took it apart because of rust . My buddy had it before me this was his picture he gave me
#31
Well is still moving in the right direction .
Big question ! I want to custom built a intake with a decent throtle body maybe 2 throtle bodies unless I find 3 smaller ones . I saw And ask Curran brothers on his 4 Rotor NA , he has 2 throtle bodies, I forgot what size he was running . I知 still waiting on parts for my cars, and while I wait for budget parts that are good , I purchase a GSL-SE so I can have a daily while I mess with all my parts for my Rx3 and my 3 rotor built .
But here is what I found on Curran痴 Facebook . I知 going stock port just polish and maybe turbo II Exhaust sleeves . I have 2 companies that are very known for building many 3 and 4 rotors .
I知 wanting them to put together my engine when time comes . But my job is to source all I want . Once I get most of my parts all ready I値l be making calls to them again and meeting them to see what I need to change etc . But I知 sure I can get some good feed back here .
Big question ! I want to custom built a intake with a decent throtle body maybe 2 throtle bodies unless I find 3 smaller ones . I saw And ask Curran brothers on his 4 Rotor NA , he has 2 throtle bodies, I forgot what size he was running . I知 still waiting on parts for my cars, and while I wait for budget parts that are good , I purchase a GSL-SE so I can have a daily while I mess with all my parts for my Rx3 and my 3 rotor built .
But here is what I found on Curran痴 Facebook . I知 going stock port just polish and maybe turbo II Exhaust sleeves . I have 2 companies that are very known for building many 3 and 4 rotors .
I知 wanting them to put together my engine when time comes . But my job is to source all I want . Once I get most of my parts all ready I値l be making calls to them again and meeting them to see what I need to change etc . But I知 sure I can get some good feed back here .
Last edited by chino_rx3; 05-18-20 at 10:36 PM.
The following users liked this post:
KNONFS (05-22-20)
The following users liked this post:
KNONFS (05-22-20)
#35
20b Run-out eshaft
Hello I had a question . I think I知 in spec per Rx7 E-Shaft specs . I checked both areas of concern . I知 hoping you guys can let me know if is good . And took couple pictures of little rust on e shaft that I知 about to clean if ok . Once I get it to shop to balance rotors I値l have them polish shaft but trying to get the most information so I know I知 ok before I got to the shop . Thanks for the help .
Thread
Thread Starter
Forum
Replies
Last Post