Hi Erdin,
On the halfbridge that I built we ran the apexi power fc successfully.
Maybe the engine needs dowelling?It could be that the power is causing the housings to move.
Kind regards
Carl

 

Hi Carl how are u, the engine has been dowelled but i was told that the ecu will need up grading and all so the why the seals r put in the rotors are gona be revised
so il have to wate and see what happends now.

Regards

Erdin

 

I am very well thanks Erdin,
Are you going to Santa Pod on the 12th of October?
I will be there all going well in my RX3,it is a tatty looking red one.Come over and talk to me if you are around.
Kind regards
Carl

 

I wont have my car yet but i think my cousin with his Supra will be there so il try and come in his car it will be nice to meet you.

Thankfully

Erdin

 

Erdin, Check the timing with a light and verify that what your getting with the timing light matches your timing on your map at idle. If its advanced you may have crossed the wires to the crank angle sensor and even though the map says your running correct timing a light will show much more advanced timing. This cost me 3 motors this year until the timing was verified with a light. Apex seals would break at the corner. No other signs and no detonation. Apex seals would break on the corners only! This is with a single turbo and 15-18 psi on pump gas. Motors kept blowing even though Air/Fuel was safe.