Apex seals and cermet coatings?
#1
Rotary Enthusiast
Thread Starter
Apex seals and cermet coatings?
I know on JHB's website they say to use their apex selas with their coatings. I was wondering what some of yahll are using that have these coatings? Should i use what they recommend or use the ra seals and oem springs?
Also which coating did you choose and would you do it again? Why?
If you have had any problems related to the coatings please feel free to share/guide.
Also which coating did you choose and would you do it again? Why?
If you have had any problems related to the coatings please feel free to share/guide.
Last edited by Crusader_9x; 07-04-05 at 04:35 PM.
#4
Likes to swear....alot
iTrader: (3)
Join Date: Dec 2002
Location: Kitchener Ontario Canada
Posts: 3,791
Likes: 0
Received 3 Likes
on
3 Posts
I have built 1 T2 motor with the JHB housings and used the OEM Mazda seals aand I'm in the process of building another one. The first motor was a little hard to start the first few times...I guess it takes a little while for the seals to set properly.
#6
Likes to swear....alot
iTrader: (3)
Join Date: Dec 2002
Location: Kitchener Ontario Canada
Posts: 3,791
Likes: 0
Received 3 Likes
on
3 Posts
Last i heard it had 4000kms on it and running great....it had some hesitation problems, which turned out to be grounding issues. Still haven't had a chance to compression check it yet.
Thread
Thread Starter
Forum
Replies
Last Post
Snook
Single Turbo RX-7's
18
10-08-15 10:09 PM