Hey guys I'm relocating my coils and need some suggestions on plug wires that I can get custom length or buy in a roll and cut to size then install the boots myself.

Anyway, have some suggestions????

What have you guys used and know is good stuff.....or bad stuff

Thanks,
STEPHEN

 

Also, anyone with experience with Taylor/Vertex. I also need cut-to-fit wires and they have some that look really nice and some domestic guys swear by them. Anyone experienced?

 

A friend bought the V8 wire kit by Accel(sp?) at the local parts store. You cut the wires to required length and crimp the ends on them. They work fine on his car. There is enough to do two cars so that's what I'm using on my car.

On a side note, we are both using distributors on 13B if that makes a difference to you.

 

Magnacore will make you custom length wires. Great company and an even better product.

 

if you want to make your own wires i would pick up some MSD universal wire kit... MSD wires have the lowest resistance of almost any wire out there. its part#3123 8.8 wires universal kit... this one comes with the right connectors and boots to fit mazda.. its a v8 kit , the kits all cost the same, so if you make a mistake or two you have some x-tras!!!! best of all you can get these wires from almost any hi-performance shop, or jegs, or summit, or paw... you can get red or blue, just specify...

 

Garfinkle makes wires from a roll of MSD wire and their ends , the resistence is 40 ohms per foot. There are several set out there all doing well.

 

i used the accel 10.8's and custom made mine, since i moved my coils also