2nd Gen 13b-rew Swap
02-06-03, 06:12 PM
#1
Junior Member
Thread Starter
Join Date: Jan 2003
Location: WATERMAN,IL
Posts: 38
Likes: 0
Received 0 Likes
on
0 Posts
2nd Gen 13b-rew Swap
HEY ANYONE OUT THERE WITH SOME WIRING DIAGRAMS FOR 2ND OR 3RD GEN 7S? ITS AN 88 GXL. JUST PULLED OLD MOTOR. I HAVE NEW MOTOR MOUNTED IN ALREADY. MADE MY OWN MOUNTS. I ALSO JUST BOUGHT AN APEXI POWER FC AND NEED TO WIRE 2ND GEN BODY HARNESSES TO 3RD GEN MOTOR HARNESS AND ECU. AFTER THIS THE CAR IS READY TO DO BIG SMOKEY ONES. HELP!
IF NOTHING ELSE A LITTLE WORD TO THE WISE WOULD HELP... ANYTHING?
IF NOTHING ELSE A LITTLE WORD TO THE WISE WOULD HELP... ANYTHING?
Last edited by MIKE FALKOS; 02-06-03 at 06:26 PM.
02-08-03, 06:35 PM
#2
Rotary Enthusiast
Join Date: Dec 2001
Location: UK
Posts: 1,271
Likes: 0
Received 0 Likes
on
0 Posts
I have just done a Rew conversion for some one.
Its as easy as this, Get your REW engine rebuild it (bit of porting too) whilst apart use a 13bt (T2) center plate,build back up ajust inlet manifold to suit then fit a Haltech E6K/E11, Done.
Or if you like you can fit a 13b RE center plate from a Cosmo and use the Bigger ports and still be able to use you stock engine mounts.
Chris
Its as easy as this, Get your REW engine rebuild it (bit of porting too) whilst apart use a 13bt (T2) center plate,build back up ajust inlet manifold to suit then fit a Haltech E6K/E11, Done.
Or if you like you can fit a 13b RE center plate from a Cosmo and use the Bigger ports and still be able to use you stock engine mounts.
Chris
