'Seca' Switch
#1
Full Member
Thread Starter
Join Date: Mar 2002
Location: California
Posts: 117
Likes: 0
Received 0 Likes
on
0 Posts
'Seca' Switch
What about this idea for those whos' engine is too loud
Might be a decent idea, just turn a **** when you pass the sound thingy!
Is your exhaust system too loud? lower the noise level, while reatining the power. I have a valve (similar to a TB) that you can put between any joints in your exhaust system. This is fully electronic, and comes with all hardware and switch. You can control the amount of opening, thus controling the noise level
#3
Has been.. hangin' around
Join Date: Mar 2001
Location: Milpitas, CA
Posts: 2,618
Likes: 0
Received 0 Likes
on
0 Posts
Yeah, i don't think I'd go that route, I'd use something like that for a cut out, where I could switch between exhaust routing out no cat, or with cat/muffler..
For Laguna, we'll see. Worst case, I setup my car to allow easy additions of turndowns, and a supertrapp if that becomes necessary (let's hope not)..
Funny, my Trans Am is far louder, but it's not so sharp, it's a dull growl instead of a high pitch whine like the RX7
PaulC
For Laguna, we'll see. Worst case, I setup my car to allow easy additions of turndowns, and a supertrapp if that becomes necessary (let's hope not)..
Funny, my Trans Am is far louder, but it's not so sharp, it's a dull growl instead of a high pitch whine like the RX7
PaulC
Thread
Thread Starter
Forum
Replies
Last Post
FC3S Timmy
2nd Generation Specific (1986-1992)
8
10-02-15 08:08 AM
Snook
3rd Generation Specific (1993-2002)
23
09-30-15 11:36 AM