Hood Pin fitment
#4
Full Member
Thread Starter
Join Date: May 2010
Location: Colorado
Posts: 131
Likes: 0
Received 0 Likes
on
0 Posts
#5
Banned. I got OWNED!!!
iTrader: (1)
Join Date: Jun 2006
Location: Denver
Posts: 697
Likes: 0
Received 0 Likes
on
0 Posts
I do not have an 84 here to check, so its hard for me to comment. Even if they did a mount or something could be fabbed up to make them work. I can check the length of some hood pis I have at the shop and let you know how long they are.
BTW I carry Sparco and other hood pins if you are close to Denver you can just come by and check them out/pick them up.
Cheers,
Don
BTW I carry Sparco and other hood pins if you are close to Denver you can just come by and check them out/pick them up.
Cheers,
Don
#6
needs more track time
iTrader: (16)
I just installed a set of those in my Miata.
Best way to answer your question is to out to the garage and measure. Start by figuring out where you want to put them. Use a ruler or something 4" in length to figure out how high it would stand. Deduct about 1/2" since the pin has 2 nuts which will sandwich the pin to whatever piece of sheet metal you decide to use.
4" should be enough.
Best way to answer your question is to out to the garage and measure. Start by figuring out where you want to put them. Use a ruler or something 4" in length to figure out how high it would stand. Deduct about 1/2" since the pin has 2 nuts which will sandwich the pin to whatever piece of sheet metal you decide to use.
4" should be enough.
Thread
Thread Starter
Forum
Replies
Last Post
erevos
2nd Generation Specific (1986-1992)
4
09-15-15 09:19 AM