ACT pressure plate weight
#1
Senior Member
Thread Starter
Join Date: Jul 2003
Location: San Jose
Posts: 291
Likes: 0
Received 0 Likes
on
0 Posts
ACT pressure plate weight
Anyone have an accurate weight for the Xtreme Pressure plate? And the 4 and 6 puck solid clutches?
I'm going to change mine and was looking at the Exedy twin disc (sprung) setup. I weighed the Exedy setup of flywheel, pp, and clutch plates at 30.4lbs.
The ACT prolite flywheel is 9.8lbs, but I can't find where I wrote down the clutch disk and pp weights. Anyone have that info handy or could weigh them?
Thanks,
Andy
I'm going to change mine and was looking at the Exedy twin disc (sprung) setup. I weighed the Exedy setup of flywheel, pp, and clutch plates at 30.4lbs.
The ACT prolite flywheel is 9.8lbs, but I can't find where I wrote down the clutch disk and pp weights. Anyone have that info handy or could weigh them?
Thanks,
Andy
#5
Senior Member
Thread Starter
Join Date: Jul 2003
Location: San Jose
Posts: 291
Likes: 0
Received 0 Likes
on
0 Posts
In any case, the intent here was to go to the Exedy twin disk that alot of folks have had positive feedback on, but hopefully not gain any weight. However, using 9.8lbs + 12.2 + xx for the ACT setup means that total is about 25 lbs or so. The Exedy setup is 30.4lbs.
So I'm either going to find another setup or have a machinist take some weight out of the Exedy (looks like there are a few areas that could be worked on). That would require the assembly to be rebalanced of course.
-Andy
Thread
Thread Starter
Forum
Replies
Last Post
83revival
New Member RX-7 Technical
4
09-03-15 10:42 PM