NEVR break front diff mount
#1
Rotary Enthusiast
Thread Starter
Join Date: Mar 2007
Location: Pasadena
Posts: 1,485
Likes: 0
Received 0 Likes
on
0 Posts
NEVR break front diff mount
I was given this link a while ago by another forum member, http://www.theg2ginc.com/fcdm/
I sent the money through paypal a few days ago, and they aren't responding. I dont havea ton of money in my bank, so I am wondering when they will recieve this order and ship it out. If they arent around I want to get my money back into my bank acccount. Anyone know what happened to them? Its been like 3-4 days and I havent gottena reply from them.
I sent the money through paypal a few days ago, and they aren't responding. I dont havea ton of money in my bank, so I am wondering when they will recieve this order and ship it out. If they arent around I want to get my money back into my bank acccount. Anyone know what happened to them? Its been like 3-4 days and I havent gottena reply from them.
#4
Rotary Enthusiast
Thread Starter
Join Date: Mar 2007
Location: Pasadena
Posts: 1,485
Likes: 0
Received 0 Likes
on
0 Posts
#6
I break Diff mounts
iTrader: (1)
The Nevr break mounts are not part of Turblown directly.
Here is a pic of my Nevr break after 3 months.
I had him install and make it on a short deadline so I assume the Urethane didn't have enough time to fully adhere/cure to the plate.
He has offered me a replacement. You may not need it but I highly recommend a pinion snubber with any new diff mount install. It took me a small dremil and a screw driver to punch the hole and 3 minutes to tighten it down and be all done.
Here is a pic of my Nevr break after 3 months.
I had him install and make it on a short deadline so I assume the Urethane didn't have enough time to fully adhere/cure to the plate.
He has offered me a replacement. You may not need it but I highly recommend a pinion snubber with any new diff mount install. It took me a small dremil and a screw driver to punch the hole and 3 minutes to tighten it down and be all done.
Thread
Thread Starter
Forum
Replies
Last Post
rx8volks
Canadian Forum
0
08-11-15 10:30 PM