Power FC wideband on pfc
Thread Starter
Full Member
Joined: Apr 2002
Posts: 171
Likes: 0
From: Orlando, Fl
wideband on pfc
Can you attach just a wideband sensor to the pfc for tuning, or do you have to buy the whole kit like the innovative wideband at rx7store. I was wondering if you could just replace the factory o2 with a wideband and datalog the o2 readings and tune the maps accordingly. Thanks.
Aneel
Aneel
Lives on the Forum
Joined: Dec 2001
Posts: 14,716
Likes: 10
From: San Lorenzo, California
No, you need to purchase a "kit". The PFC expects to see a narrowband 0-1 volt signal from the o2 sensor, not the wideband 0-5 volts. Also, the wideband o2 sensor requires the controller unit in order to control sensor temps, etc.
Rotary Freak
Joined: Mar 2001
Posts: 2,236
Likes: 1
From: San Francisco, CA
You need to buy one of these: www.fc-datalogit.co.nz/
and one of these: http://wbo2.com/. Hook them up together and then plug the datalogit into a laptop....
and one of these: http://wbo2.com/. Hook them up together and then plug the datalogit into a laptop....
Last edited by jpandes; Dec 1, 2003 at 11:55 AM.
Thread
Thread Starter
Forum
Replies
Last Post