Does anyone know where i can buy a apexi 3 bar map sensor from on its own as i already have an avcr,thanks.

 

Royston, mail me offline. I have the Apexi 3 bar fitted and can tell you its only a Denso unit. I will check it and let you know the part number.

Dan

 

and the cost is ???

 

$69 from motorsport dynamics in CA. Should be on the way, took like a month to get.

 

http://www.motdyn.com/

not listed on the web, you will have to call...

 

Here are the readings from the top of the Apexi 3 Bar map sensor.

Denso DPS-310-2000A
949940-6270 5V

So being a Denso unit, it should be able to be bought anywhere.

Dan

 

good luck finding it at a major parts store online-I haven't been able to.

 

got mine in this week...truly plug and play. Peak boost 1.45 on the commander woohoo!

 

Weaklink, where did you get it from and how much?

Thanks
Dan

 

motorsport dynamics in CA. Took a while, read the previous posts and you will get the website and phone #. It is not listed on the web, so you will have to call.

 

i just got off the phone with motor dynamics and they have no idea what i was talking about. i gave them the part number and explained it's not a factory mazda part. the guy said to ask you if you know the number they used to get it versus the actual denso part number. i really really need to get this thing. can you help?

 

I'd also like the info if anyone has it cause I need to get a 3 bar asap!!!

Thanks,
STEPHEN

 

SPOautos can i use your maps from turborx7.com ( PLEASE read my thread : maps for 1.15 bar ) .
thanks

 

after receiving an e-mail from them, they want $162+ shipping

 

Rx7Store.net

 

he doesn't have the apexi/denso unit, i've done talked to him

 

Sorry

 

does this unit have more resolution than the gm 3bar sensor?

 

no, just better oem compatability

 

Bringing this back from the past, I need a 3-bar and I dont want to buy the overpriced Apexi Map Sensor, so has anyone had luck with getting a Denso 3-Bar listed on the Apexi? And if so, where and how much!!!

Thanks...

 

GM 3 bar and PnP harness http://www.banzai-racing.com/product...er_harness.htm

 

Thanks for the link, but I was aware of the unit you had with the harness...

The main reason for wanting the Denso/Apexi unit is that i dont have to tune/set-up/configure the unit...unlike the GM!!!

 

Of course you have to setup and tune the denso/apexi unit, just like the GM. You really think you can plug it in and crank up the boost? You will be looking for a new engine very shortly if you don't tune.

 

Sorry, It came out wrong...I meant I dont have to dial in the Power FC to accept reading numbers off the GM unit to match what the OEM unit would show at atmospheric pressure...meaning +0- Or at least thats what i heard...

 

The PFC does have a preset for the apexi/denso sensor (option 1), which still needs calibrating if you want it to read "0" at your elevation. The scale and offset for the GM 3 bar is not top secret. If you have a datalogit it takes all of two seconds to set up and saves you $100.00. It is after all your car/money and if you feel like spending $200.00+ for a Map sensor, you can.