Power FC Where to begin?
#1
Rotary Enthusiast
Thread Starter
Join Date: Aug 2003
Location: SC
Posts: 959
Likes: 0
Received 0 Likes
on
0 Posts
Where to begin?
Anyone have a good starting point (mapping) for nearly stock, minus pre-; post-cats?
Currently running compression Reading of:
I would like to bring the boost down to a safe level (Don't want to blow the motor at WOT). Anyone have a good starting point other then Base Mapping that comes with the PFC? Also, I'll be installing Y-Pipes here shortly.
Any and all advice is greatlly appreciated!
Currently running compression Reading of:
9.2 8.7
9.0 8.5
9.0 8.3
and Boosting of 13.5 PSI.9.0 8.5
9.0 8.3
I would like to bring the boost down to a safe level (Don't want to blow the motor at WOT). Anyone have a good starting point other then Base Mapping that comes with the PFC? Also, I'll be installing Y-Pipes here shortly.
Any and all advice is greatlly appreciated!
Thread
Thread Starter
Forum
Replies
Last Post
Auroraw0lf
New Member RX-7 Technical
5
09-15-15 04:55 PM