Power FC When I blip the throttle in N it stutters, what do I have to adjust?
#1
Rebreaking things
Thread Starter
Join Date: Jun 2001
Location: 1 foot in Boston 1 in NJ
Posts: 2,586
Likes: 0
Received 0 Likes
on
0 Posts
When I blip the throttle in N it stutters, what do I have to adjust?
Hey guys, being the ignorant engine tuner that I am I wanted to consult before messing with anything. I've been running the PFC on the base map for a several months now(Dave fix that damn dyno please and have noticed that when I blip the throttle in neutral, it falls on its face, then recovers and responds okay. I notice the same thing under abrupt throttle increases(especially under light load). Does anyone know what I have to adjust? Also while I'm at it, when I start the car it jerks very hard, but catches right away. Could there be a connection between these two things?-ignition perhaps? My mods are listed below. I realize I need to get it dyno tuned to properly dial it in, but would like to do what I can in the mean time.
Thanks for the help
-Chris C (PFC, intake, CB, DP, flywheel, ACT)
Thanks for the help
-Chris C (PFC, intake, CB, DP, flywheel, ACT)
#2
Eye In The Sky
iTrader: (2)
Join Date: Feb 2001
Location: In A Disfunctional World
Posts: 7,892
Likes: 0
Received 114 Likes
on
66 Posts
My Ray tuned PFC has changes made to more than fuel and ignition maps. Plus I have made changes to improve my engine responce. I will give Commander instruction page number and changes.
P29 acceleration enrichment: reduce 1000rpm 2.0 ms delay time to improve initial throttle reponce. Mine is at 1.0ms.
P31 water temp correction: Ray changed 50C to 1.14 and 1.10.
I changed 50C to 1.25 and 1.15, and 30C to 1.40 and 1.30.
P32 cranking fuel: Ray set: 80C to 12, 50C to 17.3, 30C to 32,
10C to 59, -10C to 87.2 and -30C to 104.2.
P33 rpm setting: set what works best for your car.
P29 acceleration enrichment: reduce 1000rpm 2.0 ms delay time to improve initial throttle reponce. Mine is at 1.0ms.
P31 water temp correction: Ray changed 50C to 1.14 and 1.10.
I changed 50C to 1.25 and 1.15, and 30C to 1.40 and 1.30.
P32 cranking fuel: Ray set: 80C to 12, 50C to 17.3, 30C to 32,
10C to 59, -10C to 87.2 and -30C to 104.2.
P33 rpm setting: set what works best for your car.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM