Can someone please give me the correct info on what wires need to be cut or pins to be pulled. Also there used to be link on here to a power fc faq site. If this still exists will someone please post it. thanks

 

which wires to cut are in the instructions posted in the above maps and intructions section. Check it out.

 

I read somewhere that those directions were wrong or flipped. If they are not then i guess i use those.

 

no, they are right, but be very carful, the way the connectros plug into the PFC is differnt from the stock ecu, I mean the order which they plug in. Make SURE you are cutting the rigth wires, look very closely at teh diagram and make sure you don;t have the connectors flipped upside down. this happened to me, luckily it was teh one that had the 2 wires cut on both sides in exact same location.

 

How is the order that they are plugged in, any different than that of thhe stock ecu? All three sets of wire harnesses are differnt sizes i dont think you can plug them in the ecu any different.

 

I will clarify, the top of the PFC actualy coreponds to the bottom of the stock ecu. They plug in the same way yes of course plugs are certain size. You can't go wrong plugging it in. Just pay attention when you cut them, look closely at teh diagram.