Can i ask what changes i need to make here in settings 5 (or anywhere else on datalogit for that matter)

i have a map, a datalogit, a wideband and the map on but no laptop yet. car runs great to 40% cycle duty, but my resistors stop the secondaries working so im going lean in that transition area.

The map i have did not have resisitors and it looks like this, i know i need to change it, but what kind of adjustments should i make, bearing in mind, i have 12 ohm 12 watt resistors.?


settings 5

front pri 100 000
front sec 000 .25
rear pri 100 000
rear sec 000 .25

pri/sec transition 35%
sec transition (m/sec)0.500

q primary 550
q sec 1680

remember this map ran no resistors, now its got some beefy ones.
any help appreciated.

 

Resistors do not stop the injectors from working. They increase lag time.
Thus increase the lag value for them. Try a lag of .40.

 

I think the problem was due to a fault loom /crank angle sensors as that change did nothing.

solution: i have ripped out the loom and i am in the process of replacing it. Also my injectors are getting wired with fjo drivers which i have just ordered.

Is there anything i need to know about how to install them and how to change the map once this system is in?

many thanks