I have a power FC & commander the strange thing is when I look at the Maps IGT IGL & INJ they are the same right through the range.
They have for the IGT and IGL -25 in each cell & INJ has 50 in each cell
Has anybody had this problem, is it some sort of self learning mode or something?
When I had it tuned with the data logit software you could see the proper values but with the commander back on it goes back to the -25 and 50 settings

 

Does the commander read correctly when attached directly to the PFC without the DATALOGIT?

Or does it only read wrong when attached to the DATALOGIT?

My commander does not work well when attached to my DATALOGIT thus I never use the commander when the datalogit is attached and I am tuning. I only use the DATALOGIT for tuning.

 

Your tuner has checked the protect box for your timing maps and most likely your INJ map too.

 

ok thanks he must have done that.
I'll get it checked

Could that effect the tune while the data logit is hooked up

 

No it shouldn't affect the tune.

However, if you want to change your timing or any cells that are protected you will not be able to do this with your commander.

Since, I don't keep my laptop in my car at all times, I keep my timing maps protected so I don't inadvertently change my timing when fumbling through the commander screens.

You may want him to be able to make changes to your inj map from time to time, so you may want to ask him to unprotect that map.