Power FC Sensor Q's
11-14-01, 11:45 AM
#1
Junior Member
Thread Starter
Join Date: Jun 2001
Location: omaha, NE, USA
Posts: 23
Likes: 0
Received 0 Likes
on
0 Posts
Sensor Q's
After turning the engine off and leaving the accessories on, the commander reads some interesting values. My boost is reading a negative 48mmHg and occasionaly the intake air is reading negative values as well.
48mmHg works out to be about 1 psi. I think that could cause some issues but I am not sure.
Do I need to replace my intake air thermosensor and MAP sensor or is there a way that I can zero them out??
TIA
48mmHg works out to be about 1 psi. I think that could cause some issues but I am not sure.
Do I need to replace my intake air thermosensor and MAP sensor or is there a way that I can zero them out??
TIA
Thread
Thread Starter
Forum
Replies
Last Post
killerrx710
Adaptronic Engine Mgmt - AUS
5
09-28-15 09:13 AM
killerrx710
2nd Generation Specific (1986-1992)
1
09-24-15 10:57 PM
rotor_veux
2nd Generation Specific (1986-1992)
7
09-19-15 07:13 PM
