Hello,

I was wondering if anyone could be kind enough, to share with me their tune so I that can prep/make sure it run prior to getting it tune.

Engine setup:
Freshrebuilt s6 engine specs:
-Irons were only clean, no lap or refinish (mild street port)
-LIM/UIM match ported
-Housings refinish by Goopy Performance
Water Jackets - Atkins
-Rotors were only clean, inspected to be within standard specs
Apex seals- Goopy 2mm 2pc new
Apex springs- Atkins new
Corner seals- oem two 2pc new
Corner spring- oem new
Side seals- reused, double check for clearance all were within .08mm
Side seal springs- Atkins new
Oil control rings- reused within standard specs, no wear mark
Oil control ring o-rings- Atkins



Fuel Pump/Injectors/Fuel rail
-Fuel pump relay mod
-Walbro 450
-Injectors: Injector dynamics 1050x/2000
-Fuel rail: FFE 2 port fuel rails both primary/secondary

Ignition:
-Sakebomb IGN-1 coil kit


Thank you,

 

Opps, I forgot to add the turbo setup.

Turbo: Turbonetic T4, 62mm .81AR
Downpipe/header is nothing special.
Waste gate HKS 50mm

Thank you in advance.