Power FC Reset PFC Question
#1
Avoid Fuego Racing
Thread Starter
Reset PFC Question
My PFC was used and setup for Intake, IC, full exhaust. I have Intake, DP, Puched out cat, and stock CB. Should this map be ok for my setup? Also, if I do the "initialize" function on the commander, I know this resets the maps, but what does it reset them to? Would the reset map be better for my setup than the one on it? Keep in mind, I have no Datalogit.
#2
Lives on the Forum
Join Date: Dec 2001
Location: San Lorenzo, California
Posts: 14,716
Likes: 0
Received 8 Likes
on
8 Posts
Who tuned the map? Personally, I would be very wary of any pre-existing map. Unless you really trust the source, I would just reset the PFC and run 10 psi off the base map until you can get it tuned.
#3
Eye In The Sky
iTrader: (2)
Join Date: Feb 2001
Location: In A Disfunctional World
Posts: 7,895
Likes: 0
Received 114 Likes
on
66 Posts
Why isn't this in the PFC forum where it belongs?
A map for a more modded engine than yours should be safe for yours as long as the injector settup is correct.
Why, because it will have more fuel and less timing.
A map for a more modded engine than yours should be safe for yours as long as the injector settup is correct.
Why, because it will have more fuel and less timing.
Thread
Thread Starter
Forum
Replies
Last Post
24seven_dada
3rd Generation Specific (1993-2002)
20
11-10-18 12:03 PM
msilvia
3rd Generation Specific (1993-2002)
15
09-11-15 12:13 PM
Nosferatu
2nd Generation Specific (1986-1992)
7
09-05-15 02:13 PM