Power FC Power FC Idle/Throttle Response
#1
Full Member
Thread Starter
Join Date: Dec 2006
Location: Vermont
Posts: 117
Likes: 0
Received 0 Likes
on
0 Posts
Power FC Idle/Throttle Response
I have done the idle learning procedure on my PFC twice now after resetting it both times. The PFC won't even stay running through the whole thing, and then dies whenever I put the AC on, and will barely stay running normally (idles around 500 rpm). The stock ECU idles just find and will idle up whenever the AC is on or there is an electrical load, just as it should.
My car is almost entirely stock. It has a downpipe, and aftermarket boost controller, and that is it.
Thanks.
My car is almost entirely stock. It has a downpipe, and aftermarket boost controller, and that is it.
Thanks.
#3
Full Member
Thread Starter
Join Date: Dec 2006
Location: Vermont
Posts: 117
Likes: 0
Received 0 Likes
on
0 Posts
750, 850, 950.
I have tried upping the base (no load) idle and it does nothing. The idle stays at the same point. I thought this might mean a bad idle control valve, but the stock ECU seems to raise the idle just fine.
I have tried upping the base (no load) idle and it does nothing. The idle stays at the same point. I thought this might mean a bad idle control valve, but the stock ECU seems to raise the idle just fine.