Power FC Please help me choose a map
Please help me choose a map
My PFC is due to arrive in the next day or two. I have read the sticky and Chris (7-sins) has been kind enough to offer his help in showing me the ropes on the PFC. I need help choosing a map. I have a dyno tuning appointment with KD Rotary but it's not until mid October.
My mods: Street port, dp, mp, cb, Pettit lg, intake, non-seq(poor man's)
I'd like to use one of the maps from here. Does anyone have experience with mod map 6 (suganuma) or mod map 2( Houston rx7 club)? Will I be able to run high boost settings with these maps. Say 14-15 psi? Any advice you can offer would be greatly appreciated.
I could have PFS tune the car. Anybody want to offer an opinion on that?
Thanks,
Andrew
My mods: Street port, dp, mp, cb, Pettit lg, intake, non-seq(poor man's)
I'd like to use one of the maps from here. Does anyone have experience with mod map 6 (suganuma) or mod map 2( Houston rx7 club)? Will I be able to run high boost settings with these maps. Say 14-15 psi? Any advice you can offer would be greatly appreciated.
I could have PFS tune the car. Anybody want to offer an opinion on that?
Thanks,
Andrew
I don't think Peter knows the PFC so don't take it to him. He does know the PFS PMC, but not the PFC. I'll glance at the maps since its been a while and see which one is the best.
Tim
Tim
I'd personally go with modified map 2 from Chuck. The timing is less, both leading and trailing and actually has more fuel except in row 17. It will be a good starting point to then see what you knock level is with those timing maps and also the O2 sensor reading for the fuel and you can always go from there but it should be a safer map to start with.
Tim
Tim
Thread
Thread Starter
Forum
Replies
Last Post
killerrx710
Adaptronic Engine Mgmt - AUS
5
Sep 28, 2015 09:13 AM
killerrx710
2nd Generation Specific (1986-1992)
1
Sep 24, 2015 10:57 PM






