Ok I just recently did a manual swap on my FD and today when I went to get my PFC installed I ran into some problems. Here are the details. Drove the car to the shop so it was at normal operating temps, switch out the auto comp for the PFC, car fired right up, let it run for a few min. Then I turned off the car and reinstalled cover and door sill. Tryed to start the car, engine cracks but no start, no movment of the tach either. The PFC was checked out by SR Motorsports and they ran it in their 93 manual and had no problems. Has anyone had this problem or know what the fix might be?

Thanks

 

your car's auto? if so that's the problem.. auto and manual ecu's aren't the same

 

try resetting the pfc

 

how do i reset the PFC, just disconnect the battery??

 

No my car isnt auto. If you read what i posted it said i just got a manual swap.

 

nope..

No need for attitude, it's not my fault you write everything in one paragraph, if you want help be nice and submissive

There's also a difference in auto wiring and manual wiring, if you used the manual wiring it should work, if not then you gotta mod it or swap it out

PS:damn kids