Hey guys i hav recently installed a pfc in my 99' fd and since then it dosent seem to be using oil really at all, every time i check it it is full ????? does the oil metering pump still work with the pfc or do i hav to premix???

Thanks mark

 

The PFC runs the OMP. In fact, you can even adjust the injection rates using the Datalogit add-on.

 

Hey rynberg what settings tab is this under in the Datalogit software?

 

thanks for that, i was guessing that anyway, but wanted to make sure, i still cant figure out why im not using any oil??? any ideas, does the car still go into limp mode if the omp fails with the pfc?
Thanks mark

 

It's the Settings 3 page under "Oiler vs Water Temp".

No, unfortunately. However, you can check the OMP voltage on the Commander/Datalogit to make sure that is correct. You can then check the OMP and the lines themselves. Good luck.

 

Good info Rynberg, I was about to say the same thing. make sure the OMP voltage on the commander goes up into the 3s and maybe 4's on the voltage when your getting on it (into boost and load).

Tim