Power FC Pfc Idle Help
04-08-06, 03:32 PM
#1
7Azn
Thread Starter
iTrader: (2)
Join Date: Jun 2005
Location: TEXAS
Posts: 1,184
Likes: 0
Received 0 Likes
on
0 Posts
Pfc Idle Help
ok guys..i know how to search but im not gettin anything....i just have a question
i had idle problems before i installed the pfc...
i ran this mustang one or two times and everything was fine...then the next day ..i started it up and my idle was jumping up and down from 1-2000 rpm..so i had also found my tps was cracked...so couple days later i had the tps replaced and adjusted it to the factory spec...and adjusted the *** and TAS but seems to still revs...so the next day i installed the pfc ...without fixn the idlein issue...so once i installed it ..and drove it around until a month later to do the idle learning process...once i back the *** all the way out and turn it 1/2 back out ...and i sit and let it idle for 10 min, then turn on the headlights and defrost for ten mins, and then i turn on the ac full blast for another ten, during the process..i got some strange idling....first ten was high rev to 3000 rpm, next 5 it drops to 1500 rpm, then the next five it starts to bounce again .....so once 30 min was over..i back out and went half a block and came back to adjust the idle....i tried to adjust the *** counter clockwise and got high revs..then low revs...sometimes with headlights on ........and while i was adjustin them...car seem to dies oout a couple times....so i got tired of it and closed the hood and drove home........
i dont know what to do ..im stuck ...let me know on some info...
i had idle problems before i installed the pfc...
i ran this mustang one or two times and everything was fine...then the next day ..i started it up and my idle was jumping up and down from 1-2000 rpm..so i had also found my tps was cracked...so couple days later i had the tps replaced and adjusted it to the factory spec...and adjusted the *** and TAS but seems to still revs...so the next day i installed the pfc ...without fixn the idlein issue...so once i installed it ..and drove it around until a month later to do the idle learning process...once i back the *** all the way out and turn it 1/2 back out ...and i sit and let it idle for 10 min, then turn on the headlights and defrost for ten mins, and then i turn on the ac full blast for another ten, during the process..i got some strange idling....first ten was high rev to 3000 rpm, next 5 it drops to 1500 rpm, then the next five it starts to bounce again .....so once 30 min was over..i back out and went half a block and came back to adjust the idle....i tried to adjust the *** counter clockwise and got high revs..then low revs...sometimes with headlights on ........and while i was adjustin them...car seem to dies oout a couple times....so i got tired of it and closed the hood and drove home........
i dont know what to do ..im stuck ...let me know on some info...
04-15-06, 01:49 AM
#6
7Azn
Thread Starter
iTrader: (2)
Join Date: Jun 2005
Location: TEXAS
Posts: 1,184
Likes: 0
Received 0 Likes
on
0 Posts
well i finally found out the problem, i have the boost sensor unplugged, and this other hose that suppose to connect to somthing...ill have to take some pictures and give me some advice.......will post up tomorow
Thread
Thread Starter
Forum
Replies
Last Post
24seven_dada
3rd Generation Specific (1993-2002)
20
11-10-18 12:03 PM