Power FC Odd question
#1
Senior Member
Thread Starter
iTrader: (6)
Join Date: Oct 2003
Location: Elkin, NC
Posts: 291
Likes: 0
Received 0 Likes
on
0 Posts
Odd question
I searched around but couldn't really find much specifically. I pulled my engine harness out and converted it to a single, removed emissions, solenoids etc. Today I put the harness back into the car, I DID NOT HOOK UP ANY CLIPS. All I did was run it through the firewall and hook it up to the PFC>... Now, I put the key in the ignition and turned it over just for power and I looked at my screen and there was nothing. The screen was just blank. I did ground the PFC, but shouldn't at least the screen come up? Or do I need to hook everything up? I know there are grounds in the harness, would that cause it to not show up? More curious then anything... thanks.
#3
Senior Member
Thread Starter
iTrader: (6)
Join Date: Oct 2003
Location: Elkin, NC
Posts: 291
Likes: 0
Received 0 Likes
on
0 Posts
Thanks I had a feeling, just a test and see kind of thing I was doing.
PS-I love your company. Ordered a good number of things from you all and always great quality and service.
PS-I love your company. Ordered a good number of things from you all and always great quality and service.
Thread
Thread Starter
Forum
Replies
Last Post
Nosferatu
2nd Generation Specific (1986-1992)
7
09-05-15 02:13 PM