Hi guy, I just putting a power FC in my FD, I wanted to now what connectors from the engine harness I don't need anymore. I don't have the twin setup anymore, Single turbo, and I plan on using a boost controller to control boost. I took out the rats nest completely; do I need to keep the solenoids that are attached to the rats nest? What can I remove to clean up under the manifold? also am using 1600cc injectors do I need to put in a resistors because it's a low impenitence injector? Any help or advise pls... Thanks

 

Section F of the manual shows all solenoids and sensors
used by the engine wiring harness and ECU. What ever
you do not need remove it. Or look at what you need only only install those.

Example, I doubt you are running an air pump, so all controls for that are not needed. A simple process of elimination.