Power FC Need a few tips or point in the right direction
#1
Junior Member
Thread Starter
Join Date: Jul 2010
Location: Okinawa
Posts: 30
Likes: 0
Received 0 Likes
on
0 Posts
Need a few tips or point in the right direction
Basically I just got my car back running again and just installed a new PFC, obviously lost my old map. I wanna get the settings minus the fuel and ignition maps close as possible IE setting up fuel injections and such. Mods are rebuilt motor with streetport, 62-1 turbo, 550cc pri and 1680cc sec fuel pump and full exaust, FMIC running premixed gas. I have alot of kilometers to drive before its broken in and want to get the PFC setup good. Also, where can I find info on setting up the boost, I have the PFC boost controller. Need to set it for no boost and then maybe about .2 or .3 bar after its broken in alittle bit. Sorry if this hard to read because english is my second language.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
windom
Adaptronic Engine Mgmt - AUS
4
09-11-15 04:48 AM