Is there any way to run without a MOP without sending the ecu into limp-in mode. The setup I have has a modified wiring harness without connectors for it so i either have to re-wire it or figure out a way to run without it. Just wondering If anyone with a bit of experience could shed some light on this? Thanks
Andrew

 

you are asking this about a stock ECU right?

 

No, PFC. When i go into sensor check it has the MOP highlighted and no voltage values. As soon as i go above atmospheric pressure it cuts out all together.

 

The PFC doesn't care if there is a MOP hooked up or not, it does not go into limp mode. You have something else wrong.