Power FC looking for a map(mid pipe)
#1
Rotary Enthusiast
Thread Starter
looking for a map(mid pipe)
i just bought a mid pipe and would really like to put it on. my mods are as follows and was wondering if anyone can help me get it SAFE(rich is fine for now) till i can put out the money in a few months and have it tuned.
apexi pfc(duh)
hks DP
rx7 store midpipe
apexi intake
RB dual tip
9's all around(spark plugs)
stock motor
i know that i am lacking an intercooler but funds are tight for about a few months. i dont plan on running past 10lbs until i get tuned. any help from anyone?
kris
apexi pfc(duh)
hks DP
rx7 store midpipe
apexi intake
RB dual tip
9's all around(spark plugs)
stock motor
i know that i am lacking an intercooler but funds are tight for about a few months. i dont plan on running past 10lbs until i get tuned. any help from anyone?
kris
#2
Eye In The Sky
iTrader: (2)
Join Date: Feb 2001
Location: In A Disfunctional World
Posts: 7,895
Likes: 0
Received 114 Likes
on
66 Posts
Add 3.1% to 5% fuel to the top three PIM Voltage positions, and reduce your timing for rows P15-P20 for columns N8-N20 by 2 degrees. This should put you in a safe place until you get it properly tuned.
Thread
Thread Starter
Forum
Replies
Last Post