metalCORE

iTrader: (2)

Well,

i'm still waiting for my Datalogit and a date for dyno tuning. Until then i want to drive my car, that was equipped with a GT3582R over the winter, here are my mods...

Garrett GT3582R 1.06A/R/T3 flange
GReddy SpecM FMIC
Feed SonicR catback
A-Spec Manifold and Downpipe (old version)
Catless (Cat was deflated...)
850cc primaries (+ stock 850 secondaries)
NipponDenso Supra Fuel Pump

After some searching, i found some maps but no one especially for the GT3582R, so i want to ask you guys if anyone can send me one...

Another question to the tune-up for the primaries: As referring to the PFC manual, is it OK to set them to 64.5 duty cycle and +0.04ms lag? Some reported problems with idle and/or too rich load and changing these values to unbelievable -0.50ms lag and so on...but i suppose there are other ways to achieve a good setup.

I guess it wouldn't be enough to set injector sizes and let PFC do the idling process, right?

Just looking for a map that i can use until i get it tuned, not worrying about boosting the car a bit...

metalCORE

iTrader: (2)

...nobody...?