Power FC Load Does Not Change
#1
Rear Admiral
Thread Starter
iTrader: (3)
Join Date: Jul 2002
Location: St. Louis, MO
Posts: 1,685
Likes: 0
Received 0 Likes
on
0 Posts
Load Does Not Change
The car runs horribly so i checked out my PFC. The car is only using one axis. The rpms will change on the table but load will remain the same. I swapped out my PFC with another local guys PFC (same version) and it did the same thing.
This is basically what the map looks like when i turn on the map trace function.
It stays at that load at idle and when I'm moving. It does not change.
Here is my other thread. It details how I got to where I am now. https://www.rx7club.com/showthread.p...hreadid=242946
EDIT: actually my load moves on the axis above the solid mark drawn on the map.
This is basically what the map looks like when i turn on the map trace function.
It stays at that load at idle and when I'm moving. It does not change.
Here is my other thread. It details how I got to where I am now. https://www.rx7club.com/showthread.p...hreadid=242946
EDIT: actually my load moves on the axis above the solid mark drawn on the map.
Last edited by cowsniperRX7; 11-27-03 at 01:00 AM.
#4
I'm not a PFC expert, but my guess is this... When that cable grounded on the alternator, something electrical had to go. And since both PFC's act the same, id start going out from there....Would anybody else suggest testing the wiring harness next??
-Zach
-Zach
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
HalifaxFD
Canadian Forum
126
05-09-16 07:06 PM
Donald Hampton
2nd Generation Specific (1986-1992)
5
09-17-15 03:13 PM