Power FC just installed PFC, now car won't idle
#1
Senior Member
Thread Starter
Join Date: May 2003
Location: Richmond, Virginia
Posts: 323
Likes: 0
Received 0 Likes
on
0 Posts
just installed PFC, now car won't idle
i just installed my Apexi power fc and cut the 4 wires that are in the diagram. when i try to start the car, it fires up and starts for just a second then dies. does anyone have any ideas what could be wrong?
#2
Eats, Sleeps, Dreams Rotary
Join Date: May 2003
Location: MIA
Posts: 3,639
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by buzzer
i just installed my Apexi power fc and cut the 4 wires that are in the diagram. when i try to start the car, it fires up and starts for just a second then dies. does anyone have any ideas what could be wrong?
Also Ive heard the PFC takes some time to adjust everything to your car.
#4
Senior Member
Join Date: Apr 2001
Location: Boston, MA, USA
Posts: 334
Likes: 0
Received 0 Likes
on
0 Posts
Make sure you cut the right wires - make sure that when you looked at your harness you are looking at the same side of the plug as the diagram. That is, make sure you weren't looking at the harness-side plug to determine which wires to cut if the diagram was showing the pfc-side - or vice versa.
If your idle just bounces and/or revs then you just need to let it run for some time at idle (like 10 mins) - even after that it might take sime time to sort out. Ilde may bounce at stoplights on hot days for awhile, but it should work out fine. It took a couple of months for these issues to go away completeley when I replaced my pfc with a new one.
that said - stalling out isn't normal - fist think - check for correct wires - then start looking at other things that you may have touched/disturbed. Loose connections, leaks, etc.
If your idle just bounces and/or revs then you just need to let it run for some time at idle (like 10 mins) - even after that it might take sime time to sort out. Ilde may bounce at stoplights on hot days for awhile, but it should work out fine. It took a couple of months for these issues to go away completeley when I replaced my pfc with a new one.
that said - stalling out isn't normal - fist think - check for correct wires - then start looking at other things that you may have touched/disturbed. Loose connections, leaks, etc.
Last edited by ech; 07-26-04 at 11:12 AM.
#5
Senior Member
Thread Starter
Join Date: May 2003
Location: Richmond, Virginia
Posts: 323
Likes: 0
Received 0 Likes
on
0 Posts
the car was running perfectly before i installed it. and while it is started for that one second the commander is getting all the readings
Last edited by buzzer; 07-26-04 at 11:22 AM.
#6
Avoid Fuego Racing
I did a little write up on how to set your idle with your PFC, so that it will idle perfectly. Here is a link.
https://www.rx7club.com/power-fc-forum-47/c-sensor-issue-assistance-please-330754/
https://www.rx7club.com/power-fc-forum-47/c-sensor-issue-assistance-please-330754/
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM