I just got my car on the dyno and I am happy with the result but there is this little problem i have.
It idled fine before everthing(did get rid of a few things and installed 1200cc sec. inj.). After all this new stuff was in, the car doesnt idle nice anymore. I was told the bac valve was bad. It was good when i got there. Did they miss something? Is the new set up at fault here? I want to get a few ideas before i go ahead and buy a new bac valve
TIA

 

Play with your idle settings before buying anything, it's free.

Do you have a datalogit or access to one? I believe there are idle settings you can access with it that aren't accessable via the commander. I'll find out for sure next week when I tweak my idle due to lightened flywheel.

k

 

thanx, i did play with the idle control on the PFC and it does react to it a bit. what i found is that it enjoys the electrical load...parking lights on=idle nice, pl off and it hunts every once in a while
hehe, go figure!