Does anybody have any base maps for the ID 725s and ID2000s injectors for the FC3S i can try until i get my tune in a month or so? I have a 91 TII with the ap engineering PFC. My turbo is the Aspec T4 GT3574 with 0.84 A/R and 44mm tial WG and greddy FMIC. Running a paraller fuel system with 40 psi base pressure. I made the changes in the settings 5 with my dataloggit.

Thanks guys.

 

Properly setting up the primaries will keep idle through cruise almost identical to stock in AFR. I have tested this. Have not tested it for the secondaries. But as long as you keep boost low(below 5, you are safe.

 

What did you use for the setting for the ID2000s? I have the same injector setup and am getting ready for a tune, but ID doesn't supply the 40psi numbers for the 2000s

 

What i did was to find the difference between the 45psi values and the 43.5psi values for the different voltages and then subtract that difference from the 43.5psi. Its not the right way to do it but this is what i did :-)

You can raise your fuel pressure to 43.5psi and use the exact values given on their data sheet. I am thinking of doing that too.