Okay, so I thought I had everything figured out but I may be way in over my head. I have 3 questions, if anybody can answer any of them that would be very helpful. First when adjusting fuel maps, it's in percentages. What does this percentage represent, 114% of what? Second, I have an s4 TPS and the instructions say to splice it in to wire 3F, but it doesn't tell where or what this wire is? Finally, what do I need to do with my wideband. I have an innovate LC-1 setup. The instructions say nothing about using an O2 sensor. Do I splice a wire right into the O2 sensor or do I run it through my Innovate LC-1? Or does the Power FC not need the O2 sensor and it stays completely separate?

 

1. 1.14 is a 14% increase over the base map.
2. It is exactly what the instructions says it is, connect the FRT to 3F. Otherwise the PFC will not see a FRT signal Banzai Racing S4 RX-7 Power FC Installation
3. Turn off the O2 feedback control or wire the analog output of the wideband to the O2 input of the PFC

 

What or where is 3F?

 

And does the Power Fc use the O2 sensor signal for anything. If not how do I turn it off?

 

If you bought the adapter new from us, then the wires were clearly marked, if you bought it used then download the pinout.

Read the instruction for the PFC or make arrangement to have your car tuned by a professional.

 

I bought it brand new from you guys. I have the instruction manual from you. But it does not tell where 3F is. I'll look again on the adapter harness for a wire marked 3F.

 

Everything is labeled, SS, Frt, BC, 3F, KS, COR