Power FC do you have to use the oem sensors
Thread Starter
Junior Member
Joined: Dec 2003
Posts: 23
Likes: 0
From: uk
do you have to use the oem sensors
not on an rx7 but you guys seem to have an awesome knowledge on the power fc..
ive just removed a haltech e6k from my celica gt4 and am replacing it with the power fc,i have the gm water and air temp sensors still installed on the car,will the power fc work fine with these or will i need to refit the toyota sensors?
just asking as i have had the gm sensors helicoiled in so to refit the oem sensors would be a little difficult lol
thanks guys
ive just removed a haltech e6k from my celica gt4 and am replacing it with the power fc,i have the gm water and air temp sensors still installed on the car,will the power fc work fine with these or will i need to refit the toyota sensors?
just asking as i have had the gm sensors helicoiled in so to refit the oem sensors would be a little difficult lol
thanks guys
To be accurate, they would have the same voltage curve as stock, otherwise the reading would be off. You can live with that if you calibrate the readings so you know exactly what they respresent.
Originally Posted by gt4mainman
i can get the specs for the haltech/gm sensors easy enough so is it possible to calibrate this within the power fc software? i dont have the power fc yet so cant tell.
Thread
Thread Starter
Forum
Replies
Last Post
Skeese
Adaptronic Engine Mgmt - AUS
65
Mar 28, 2017 03:30 PM
stickmantijuana
MoTeC
5
Sep 10, 2015 07:58 PM