I just wired up my electric fan. following the instructions. chris has on his site he did the install of the pfc and tune at banzai a few years back. So I know the job was done by one of the best out there. I've checked all my wireing and my relay every thing checks out. Chris says to get the trigger signal from the single green diagnostic connector. I know his harness accomodates this. I'm not sure mine does I bought my adapter harness used.

Any one know what terminal the pfc sends the fan 2 trigger signal out on. I'm thinking I could run my trigger signal wire straight to the pfc.

Or open to any other viable alternative.

thanks for any inputs

 

Josh- you have an AP PFC, which does not have the fan control wire in the adapter. Also the map you have is not set up to turn the fans on.

 

Thanks Chris had the feeling you made some changes to your harness. I've got a data logit to change the map with.

 

http://www.geocities.com/arghx/PowerFC.FC3S.Tuning.doc go to the last page, it has what you are looking for