please help me out i dont know how to set the % and ms....

i already search so many time but still cant get an answer.

my setup is street port , T60-1, RC injectors.

thank you very much

 

injectors are 850 and 1300

right now is set at 68% pr and when i boost at 14 psi my injector duty is at 89% already.

that is not normal right ?

also what fuel presure is good for this setup ?

thank you again

 

550/850 = 64.7%, how did you get 68% for the primary precentage?

Use a base FP of 38-40psi at 0 boost.

Primary inj lag is set by adjusting it to get ball park smooth idle as 850s will somtimes run too rich to allows using the fuel correction map. Search on 850 and read many threads about 850 primaries.

Secondary inj lag of .10 for #1 and .20 for #2.

All of this has been posted many times.

 

thank you for your reply , the 68% was done by the last onwer. so i will correct that , to

65.0? and the secondary inj lag what do u mean by #1 and #2 ?

i did seach the fourm for a long time but cant get any answer, so that is y i post a new

thread.

thank you for you time.

 

Did you switch out your secondary injectors? the original owner was running 4 850's not 1300's.

 

yes i did the RC1300cc

 

The rear rotor(2) tends to run a little leaner than the front rotor(1) thus a little more lag makes it run a little richer.

 

ok so that means .1 in the front and .2 in the back right ? Also i set the PR 850 to 65 % will

that work ?

again thank you very much

 

no one is 100 % sure about that ? what are your setting ? no body use 850/1300 ?

come on please help....

 

PMed you.