hey, I have installed a full bridgeported motor to my time attack fd, I need to start and run it in before proper tuning.

I have datalogit and software, can anyone recommend me a base map ? am afraid of playing with ign timing and i think i have to make some changes for a ported engine

 

Stock base map pretty much works for any setup for starup after you adjust the injectors and idle... And fueling of course if you want to drive it around off boost.

thewird

 

Large ports need negative split for idle and low loads.

 

thanks for the info, what leading timing would you recommend for startup? and how much split difference?

 

Just ignore the negative split thing until you get it going lol. Keep it simple

thewird

 

i cant make it idle thats the problem, and its ver very hard to start up

 

Turn the idle screw up to raise the idle. AFR should be around 12.0 . You can run it a little leaner later but having it rich will make it easier for now.

You should also untick the idle control checkbox and set all the idle values to 0 to disable idle control. That way your full manual off the screw.

thewird

 

thanks alot for the tips I will go and try tomorrow and let u guys know