Power FC is base map safe
is base map safe
If I have my boost turned all the way down my car runs about 4-5lbs of boost on my t78.. would the base map be safe for me to drive on or is there another map that would work. I have stock injectors, upgraded fuel pump, aromotive FPR, Street port, 3mm apex seals, t78, fmic, pulleys, full exhaust.
matt
matt
NO..... Get it properly mapped. I would hate to see a rotary engine die due to running lean.
You are running porting, full exhaust system, front mount, big turbo, etc. so even with the uprated pump the car is still most likely running lean up top.
At least get it checked on a set of rollers.
Dan
You are running porting, full exhaust system, front mount, big turbo, etc. so even with the uprated pump the car is still most likely running lean up top.
At least get it checked on a set of rollers.
Dan
It should be ok for the idle and rev bit, but I wouldnt want to go driving it around without getting it properly looked at.
Do you have a wideband O2 sensor? This will help to tell if you're running lean or not.
Dan
Do you have a wideband O2 sensor? This will help to tell if you're running lean or not.
Dan
Trending Topics
The base map will work if you are not going to be boosting it and you just want to drive around town. I dont make any changes to the map until higher boost levels. Just dont boost it high in the RPM range.
Jason
Jason
I drove on the base map with my rx6 during the entire break in period and a little beyond with nary a hiccup, boosting to 14-15psi after breakin with <20 knock and <10.5 on the wideband. Hey Jason, how come you don't answer my emails for a map???
Full Member
Joined: Dec 2002
Posts: 169
Likes: 0
From: Tucson,Arizona
Jason,
Do you have a map for 1600cc secondaries, and a single turbo. I am having one hell of a time trying to find one for now.
MohaveB@msn.com
Thanks
Mods:
550cc prim
1600cc second
FMIC
Exhaust
HKS twinpower
Do you have a map for 1600cc secondaries, and a single turbo. I am having one hell of a time trying to find one for now.
MohaveB@msn.com
Thanks
Mods:
550cc prim
1600cc second
FMIC
Exhaust
HKS twinpower
Thread
Thread Starter
Forum
Replies
Last Post
danielbradley2
3rd Generation Specific (1993-2002)
11
Sep 28, 2015 10:44 PM
befarrer
Adaptronic Engine Mgmt - AUS
3
Sep 22, 2015 09:33 AM




