I have these wired in my FC and am using the Auber Gauges to moniter both rotors. I would like to wire each sensor to my Datalogit but am unsure how to do this...I have connected other sensores to include my Wideband but these EGT's are leaving me in the dark.

I have attached the link with the directions. Any help is appreciated. Thanks guys.

http://auberins.com/images/Manual/AU...ruction1-0.pdf

 

You need a signal conditioner with 0-5V analog signal outputs. AEM, Innovate, or others have boxes like that, e.g. http://www.aempower.com/images/produ...%2030-2204.pdf

That unit does not have that. The 5V listed as outputs are fixed voltage to power extra sensors (like a RTD).

- Sandro

 

The Innovate TC-4 does not have a 0-5v output. The AEM does and is priced about the best of any decent box of it's kind. I've recently seen these inexpensive conditioners popping up in different threads and am wondering if they're just too good to be true for the price.

http://jbrlsr.com/?aid=5336108635&bi...p%3Ft%3D791104

 

https://www.rx7club.com/3rd-generation-specific-1993-2002-16/dual-digital-egts-612960/

This is a great thread on egt's and converting the signal so the datalogit can read it