I'm just double checking I acquired new ev14 style injectors and am on the settings 5 tab prim inj vs. Bat. if I input the numbers from Injector dynamics website by converting micro (usec) to milliseconds. For both primaries and secondaries and inputting the new numbers in the boxes do I just set the lag times all to zero now?

 

yes

 

Evidence that someone does not really understand what they are doing with the table .
Old way of just changing lag when you do not have the voltage vs lag info compared to having the lag info.

 

Yes your right I'm just starting out thanks for pointing it out. I'm just learning to crawl before I walk. When I was going through your notes in the settings 5 chapter it did not cover the bat v vs the injectors. It does mention the old way which I'm aware of.

 

I got a used AP Eng PFC for a S5 TII

it was configured for stock injectors. I swapped the secondaries for bosch 1680cc and used 3.3 Ohm resistor. then pri/sec transition was not smooth at all, lean spot.

to cure this I almost doubled the values in the lag time vs batt volt for the secondary injectors, reduced the transition time to 0.3, is as smooth as butter now =)