Am i doing this right Injector setup questions.
I'm just double checking I acquired new ev14 style injectors and am on the settings 5 tab prim inj vs. Bat. if I input the numbers from Injector dynamics website by converting micro (usec) to milliseconds. For both primaries and secondaries and inputting the new numbers in the boxes do I just set the lag times all to zero now?
|
yes
|
Evidence that someone does not really understand what they are doing with the table .
Old way of just changing lag when you do not have the voltage vs lag info compared to having the lag info. |
Yes your right I'm just starting out thanks for pointing it out. I'm just learning to crawl before I walk. When I was going through your notes in the settings 5 chapter it did not cover the bat v vs the injectors. It does mention the old way which I'm aware of.
|
I got a used AP Eng PFC for a S5 TII
it was configured for stock injectors. I swapped the secondaries for bosch 1680cc and used 3.3 Ohm resistor. then pri/sec transition was not smooth at all, lean spot. to cure this I almost doubled the values in the lag time vs batt volt for the secondary injectors, reduced the transition time to 0.3, is as smooth as butter now =) |
All times are GMT -5. The time now is 09:53 AM. |
© 2024 MH Sub I, LLC dba Internet Brands