Power FC 750cc primary injectors
09-12-03, 07:11 AM
#1
Senior Member
Thread Starter
750cc primary injectors
I'm going to be cranking up my new fuel config soon & am looking for some suggestions for injector settings. I have all top feed injectors 756cc Primary & 1680cc secondary.
What is the suggested Primary percentage (I'm guessing 73%), Lag settings, and Injector overlap settings?
TIA.
What is the suggested Primary percentage (I'm guessing 73%), Lag settings, and Injector overlap settings?
TIA.
09-12-03, 10:24 AM
#3
Senior Member
Thread Starter
Originally posted by Tim Benton
Did you have to replace the fuel rail as well for the primaries?
Tim
Did you have to replace the fuel rail as well for the primaries?
Tim
09-12-03, 04:09 PM
#4
Cool, just wondering since I knew the stockers were side feed and the fuel line more than likely wouldn't work.
73% would be the percentage..as far as lag settings, not really sure since it will vary with the manufacturer. What kind of injectors are they, made contact the tech department of the manufacturer and ask them what the lag is in ms.
Tim
73% would be the percentage..as far as lag settings, not really sure since it will vary with the manufacturer. What kind of injectors are they, made contact the tech department of the manufacturer and ask them what the lag is in ms.
Tim
09-15-03, 07:36 AM
#5
Senior Member
Thread Starter
Originally posted by Tim Benton
Cool, just wondering since I knew the stockers were side feed and the fuel line more than likely wouldn't work.
73% would be the percentage..as far as lag settings, not really sure since it will vary with the manufacturer. What kind of injectors are they, made contact the tech department of the manufacturer and ask them what the lag is in ms.
Tim
Cool, just wondering since I knew the stockers were side feed and the fuel line more than likely wouldn't work.
73% would be the percentage..as far as lag settings, not really sure since it will vary with the manufacturer. What kind of injectors are they, made contact the tech department of the manufacturer and ask them what the lag is in ms.
Tim
Thread
Thread Starter
Forum
Replies
Last Post
HalifaxFD
Canadian Forum
126
05-09-16 07:06 PM
Donald Hampton
2nd Generation Specific (1986-1992)
5
09-17-15 03:13 PM