i just ported my motor and rebuilt it... car is pulling around 450 vac at 1500 rpms. i have 850x4 set the primaries to 64.5% at +0.04ms, i did the intializing part to reset the commander/ecu and did the idle learning process, or is there a setting that you have to go to to start the idleing learning process?

i let the car sit there for about 35 minutes and it stay at 1500rpm, any ideas?

 

Search for my post on this forum about this same subject, or buy my tuning notes.

PFC idle questions are the most common question on this forum since it was created.