Any Ideas?
#1
Supa supa
Thread Starter
Join Date: Feb 2004
Location: louisville, kentuk
Posts: 225
Likes: 0
Received 0 Likes
on
0 Posts
Any Ideas?
I was wondering about doing a v6 conversion. DOes anyone know anything about this? Like what I would have to do etc and stuff like that. Guys give me your input. Also like price for engine/cost things like that.
thanx Reece
thanx Reece
#2
You will be going down a path less traveled so costs will be higher for fabracation of mounts, driveshafts, etc. That being said, there is some good information on using the GN turbo motors in FCs with great success.
There have been some posts not too long ago for complete drivetrains and mounting equipment for the GNs over on torquecentral.com.
There have been some posts not too long ago for complete drivetrains and mounting equipment for the GNs over on torquecentral.com.
#3
i say what i want
Join Date: Aug 2002
Location: richmond, va
Posts: 1,866
Likes: 0
Received 0 Likes
on
0 Posts
my dad did a 4.3 chevy in his fc. theres some out there, and i dont know the deal with them, but a couple years back grannysspeedshop.com helped out alot and had the mounts. also, its not going to be harder and more expensive. the v6 doesnt take up at much room, so more stuff fits, like a/c, and you can keep the radiator in the stock location.. ect. you can get decent power out of a v6, but personally, if i was going to do a swap like that, i would do a v8.
#4
Supa supa
Thread Starter
Join Date: Feb 2004
Location: louisville, kentuk
Posts: 225
Likes: 0
Received 0 Likes
on
0 Posts
yea i was thinking that too, i dont wanna be lauching and just sitting around peeling out? But like what would i need to change and maybe estimated cost and places that could do a v8/v6 conversion. Plus i heard alot of bad things bout granny.
thanx reece
thanx reece
Thread
Thread Starter
Forum
Replies
Last Post